• Tandem mixer for CH47, CH46 etc.
• NEW COAX software for  KMAX /V22, Coaxial, etc type aircraft.
• NEW UMIX universal mixing software - Create any 5x8 mixing you want.
  
  Uses our Tech Link USB PC software for programming and setup.

 Usually ships in 1 to 2 weeks from order date.

These extender boards allow you to separate the servo power and signal wires for large/digital servos
and for long wire lengths.  The power wires run directly from the extender boards to the battery/BEC
which supports the use of larger capacity wire.  The header pins  have a 0.1 inch spacing for plug and
play connectivity.

Same as above but requires assembly.  Soldering skills and tools required.

This input/output cable is much slimmer and neater to install than six individual
male/male 3-wire cables.   Only the signal wires are present. 
A six pin connecter plugs directly into the TH-2 XPR header pins.
Cable is about 12 inches (30cm) long with different colored wires.
Use with extender boards for use as an output cable.

Mini-B USB cable (5 pin), 6' long, used for connecting our TH-2 USB devices to your PC.
 

This boards allows plug and play power connectivity from the BEC to the flight electronics.
Additional connection pads provided for customization.  Three mounting holes.

Same as above but requires assembly.  Soldering skills and tools required.

Perfect for powering the TH-2 and on board electronics.
Input 3S to 10S.  Soldering skills and tools required.

                            Connectors

The Twinn Rexx is back and better than ever.

This base kit includes the frame and all mechanics. 
Note (Rotor heads (2), electronics, and electrics) are not included in this kit.

See the product details for more info -->

 Recommended Parts

Video  This video features pilot Jorg Nickel and his legacy Twinn Rexx

Video  This video features pilot Alistar Burgess and his 3-blade Twinn Rexx

Made in the USA.       

Note:  USA Lower 48 only.  AK, HI, and INTL: Email for quote for shipping.

The Twinn Rexx is back and better than ever.

This kit includes the base kit as above + HD upgrade package. 
Note (Rotor heads (2), electronics, and electrics) are not included in this kit.

See the product details for more info -->

 Recommended Parts

Video  This video features pilot Jorg Nickel and his legacy Twinn Rexx

Video  This video features pilot Alistar Burgess and his 3-blade Twinn Rexx

Made in the USA.       

Note:   USA Lower 48 only.  AK, HI, and INTL: Email for quote for shipping.

CH47 Chinook sport scale body for the Twinn Rexx tandem.

Kit includes: L/R body panels, frame mounts, hardware, plastic/foam frame supports.
See the product details for more info -->

Made in the USA.

Note:  USA Lower 48 only.  AK, HI, and INTL: Email for quote for shipping.

M2x6 stainless steel button head screws with nylon nuts (20 sets).

Nuts get glued (CA) to the mounting tabs.

Screw heads use 1.27mm hex tool (not included).
 

Scale looking "single" rear wheels kit that bolt on without modifications.

Includes wheels, axel mounts, axels set, spare washers and installation tool.
 

CH47 Chinook sport scale engines kit for the Twinn Rexx tandem.
Kit includes: Formed plastic parts for two engines, instructions and assembly diagram.

Made in the USA by Ryan Aircraft.

12 tooth pinion gear for 3.5mm motor shaft.

.
 

11 tooth pinion gear for 3.17mm (1/8") motor shaft.

.